tekmar 481 User Switch Installation - Manual (Page 3)

3 of 12 © 2009 D 481 - 07/09
Current Scene
Press the
Same Button
New Scene
Perm Scene 1 No Change
Perm Scene 2 - Away Selects Scene 1
Perm Scene 3 - Unoccupied Selects Scene 1
Perm Scene 4 Selects Scene 1
Perm Scene 5 Selects Scene 1
Tmpy Scene 6 - Occupied Selects previous perm scene
Tmpy Scene 7 Selects previous perm scene
Tmpy Scene 8 Selects previous perm scene
The 3 User Buttons provide the ability to:
1) Select a scene for the tN4 system
The User Buttons allow users to select the scene of the tN4 system. Each of the 3
User Buttons is programmed by the installer to select a particular scene on the tN4
system. The temperature of each tN4 thermostat in the system is pre-programmed
by the installer for each of the scenes. This allows users to change the temperature
of all the thermostats using a single button.
tN4 thermostats and tN4 setpoint controls must have Scenes turned to “On” in order
to respond to scene changes on the User Switch.
When a User Button is pressed, the green LED under that button turns on and
remains on until a new scene is selected, or the time for the selected temporary
scene expires.
When the current selected scene on the tN4 network is the same as the scene that
the User Button is programmed for, the button turns green.
When a selected scene is “On” and that User button is pressed again, the scene is
changed based on the following table:
Application Examples:
Allows residential users to change the scene to 2 (Away) while going on vacation,
or select an occupied scene while entertaining guests.
Allows commercial users a simple way to allow staff to override the night setback
/ setup schedule on the tN4 system.