tekmar 481 User Switch Installation - Manual (Page 6)

© 2009 D 481 - 07/09 6 of 12
STEP 5
Press button “B” to finalize the User Button setting and
exit the programming mode.
Note: To return to Step 2 without saving the setting,
press button “A”.
STEP 6
Repeat steps 2 through 5 to program each User
Button.
STEP 7
Included with the User Switch are labels to identify
the operation of each User Button. Each label has a
description on it. Choose the label with the appropriate
description for each button.
A template has been included on Page 10 to create
your own labels.
Insert the label into the slot located under the right
hand side of each User Button.
Repeat for each User Button.
User
Button
1
User
Button
2
User
Button
3
Press “User” Button Setpoint Enable Green Light Flash Sequence
1 Time 1 1 Green, Off, Repeat
2 Times 2 2 Green, Off, Repeat
3 Times 3 3 Green, Off, Repeat
4 Times 4 4 Green, Off, Repeat
5 Times 5 5 Green, Off, Repeat
6 Times 6 6 Green, Off, Repeat
7 Times 7 7 Green, Off, Repeat
8 Times 8 8 Green, Off, Repeat
9 Times 9 9 Green, Off, Repeat
10 Times 10 10 Green, Off, Repeat
11 Times 11 11 Green, Off, Repeat
12 Times 12 12 Green, Off, Repeat
STEP 4 (Continued)
(Setpoint Device Enable, Green Flashes)
Press the User Button the number of times equal to the desired setpoint device
enable number.
User
Button
1
User
Button
2
User
Button
3
PRESS
BUTTON
B