tekmar 483 tN4 Gateway - Manual (Page 8)

© 2011 D 483 - 12/11 8 of 20
Database Population Time
The tekmarNet ® Gateway requires approximately two minutes
per thermostat and setpoint control to populate the database.
You may login at any time although some information may
not be available until the database is complete.
Direct Access
To access the tekmarNet ® Gateway web pages on the Mac
web host computer, click on the Safari web browser and
enter the following IP address:
http://localhost:3000
The gateway login page will appear. Bookmark this address
to the web browser to allow quick and easy access to the
tekmarNet
® Gateway.
Login Page
During the initial installation, the Unlock / Lock switch must
be set to Unlock to enable the default login “installer” and
the default password “tekmar”. The login and password
are case sensitive.
After personalized login accounts have been created it is
highly recommended to set the Unlock / Lock switch to
Lock to prevent unauthorized access.
Make sure to record your login and password for future
reference.
Home Page
The home page shows the basic details of the tekmarNet ®
Gateway.
Configuration Pages
Click on ‘Configuration’ to enter the Configuration Pages
section.
Job Site
Enter the job site name, street location, building owner
contact information and installing contractor information.
A custom image of the building can be uploaded to the
gateway. It is recommended that the image size be 1 mb
or less. The image will be displayed on the home page.
General
Select either Fahrenheit or Celsius as the temperature
units for the tekmarNet
® Gateway. The clock time format
can be set to either 12 hour time or 24 hour time.
tekmarNet ® 4 Gateway Web Pages
Login Page
Home Page
Job Site
General