Coleman 5110 - Manual (Page 24)

Ц Ц Attach an LP Cylinder to the
Grill.
20-A
Cylinder Support
LP Cylinder
20-A. Set LP Cylinder in the Cylinder Support with the outlet
valve facing toward the front of the grill.
20-B
20-B. Tighten the Cylinder Hold-Down Bolt against the bottom
cylinder collar.
Cylinder Hold-Down Bolt
20-C
Type 1 Nipple
Fuel Valve Outlet
20-C. Insert the TYPE 1 Nipple of the regulator into the cylin-
der’s Fuel Valve Outlet as shown. Turn the regulator
hand wheel clockwise to tighten. No tools are needed.
The hand wheel will come to a complete stop when the
connection is secure, and gas will not flow until a positive
seal is achieved.
IMPORTANT!
T
O ENSURE PROPER GAS FLOW
,
BURNER
CONTROL VALVES MUST BE
“OFF”
BEFORE
OPENING THE GAS CYLINDER VALVE
.
WARNING:
During assembly of
grill and when attaching or replacing the
L.P. gas cylinder, insure that the gas sup-
ply hose is free of kinks and/or damage
and is at least 3” away from hot surfaces
such as the grill casting.
Step
20
NOTE: Step 20 applies to you only if your grill is set up from the factory to use LP GAS. If your grill is set up from the factory to
use NATURAL GAS, skip to Step 21.
24