Cabletron Systems NBR-420 - Manual (Page 25)

Chapter 3: Installation
Page 3-8 NBR-SERIES Installation Guide
Figure 3-3 Installing a FLASH SIMM
Install a FLASH SIMM as follows:
1. Insert the SIMM between the connector teeth in the SIMM slot.
2. Pivot the SIMM back until it locks into the clips in the SIMM slot, and
the SIMM holes fit over the SIMM slot posts.
The components and boards associated with the NBR are
sensitive to static discharges. Be sure to use an antistatic wrist
strap and observe all static precautions during this procedure.
Failure to do so could result in damage to the NBR.
2
1
SIMM
Clips Connector
Teeth
SIMM Slot
SIMM Hole
SIMM Slot
Post
1092_08
!
CAUTION