Cabletron Systems NBR-420 - Manual (Page 49)

Chapter 4: Troubleshooting
Page 4-8 NBR-SERIES Installation Guide
To Exit
There are three ways to exit the Static System messages:
• From the last Static System message
Momentarily press the DISPLAY button while the last message
“COM 2 Port Function xxxxx” is displayed. The display automatically
returns to the product name.
• Automatic 20-second exit
Allow 20 seconds to elapse after the last DISPLAY button operation.
The display returns to the product name.
• Jump to Alarm messages
Press and hold the DISPLAY button for 3 seconds. When released, the
display steps to the Alarm message described in Section 4.3.3.
Displayed Messages Comments
Host IP Address
xxx.xxx.xxx.xxx Displays the IP address of the NBR.
Can change IP address in Local Management.
MAC Address
00001dxxxxx Displays the MAC address of channels A, B, C, D,
E, or F.
RAM Image
Rev. xx.xx.xx Displays the revision number of the FLASH
EEPROM.
Boot PROM
Rev. xx.xx.xx Displays the revision number of the internal Boot
PROM.
Flash Programmed
xx Times Displays the number of times a new software
load to FLASH occurs.
COM 1 Port
Baud Rate xxxxx
Displays the baud rate set in Local Management.
COM 1 Port
Function xxxxx Displays the current function of the COM 1 Port
(OFFLINE, UPS, CONSOLE).
COM 2 Port
Baud Rate xxxxx
Displays the baud rate for COM 2 port.
COM 2 Port
Function xxxxx Displays the current function of the COM 2 Port
(OFFLINE, UPS, CONSOLE).