Tweco PCM-62 Machine Torch - Manual (Page 19)

Manual 0-2817 3-3 INSTALLATION
7. Place the lug on the Pilot Control Wire onto the
stud and secure with the nut and washer removed
in the above Step.
8. Tighten the Through - hole protector onto the
Torch Leads.
9. Check the torch for proper parts assembly.
CAUTION
The torch parts must correspond with the type of
operation. Refer to Section 4.04, Torch Parts Se-
lection.
B. Machine Systems (Unshielded Leads)
1. Remove the Through - hole protector Nut from
the Through - hole protector.
Thru - Hole
ProtectorNut
Thru - Hole Protector
Torch Leads
Assembly
Art # A-03847
Figure 3-5 Through - hole protector Nut Removal
2. The Adapter supplied with the Power Supply
must be installed per the following:
a. Inside the Power Supply Bulkhead area, route
the connector on the free end of the Adapter
through the Through - hole protector Nut.
b. Continue routing the connector out the hole
in the front of the Power Supply.
c. Pass the end of the torch lead and the Through
- hole protector into the hole in the unit while
routing the single black wire into the notch of
the Through - hole protector.
d. Tighten the Through - hole protector Nut to
secure the Through - hole protector to the
Power Supply.
3. Connect the torch Negative / Plasma Lead to the
bulkhead connection inside the Power Supply.
Adapter
(Supplied With
Power Supply)
Pilot Lead
Torch Lead
Assembly
Negative/Plasma
Lead
Adapter
Connector
Pilot Lead
Stud
Negative/Plasma
Lead Connection
A-02768
Control (PIP) Circuit
Connectors
Shield Connectors
(Not Used)
Remote
Cable
Connector
Note: Actual Bulkhead
configuration may
differ from that shown.
Figure 3-6 Torch Lead Connections For CutMaster
50 Power Supply
Adapter
(Supplied With
Power Supply)
Pilot Lead
Torch Lead
Assembly
Negative/Plasma
Lead
Adapter Connector
Pilot Lead
Stud
Negative/Plasma
Lead Connection
A-02828
Control (PIP) Circuit
Connectors
Shield Connectors
(Not Used)
Remote
Cable
Connector
Figure 3-7 Torch Lead Connections For PakMaster
50XL Plus Power Supply