Cisco 7912G - Manual (Page 151)

A-29
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
Appendix A Reference List of Parameters
Configuration Parameters
Tip To access the Call Preferences area directly from a web browser, enter
IP_address/ToneConfiguration, where IP_address is the IP address of your
Cisco Unified IP Phone.
Table A-8 Tone Parameters
Parameter Description
SigTimer Timeout values for signal events.
• Bits 0–7: CWT Period, which the number of 0.1-second intervals to wait
between each burst of call-waiting tone. The range is 0 to 255. The default
value is 100 (0x64, 10 seconds). 0=Use default.
• Bits 8–13: Reserved.
• Bits 14–19: Ring Timeout, which is the number of 10-second intervals to
wait between when the phone starts ringing and the phone rejects the
incoming call. Range: 0 to 63. 0=Never time out. Default value: 6 (0x6,
60 seconds).
• Bits 20–25: NoAns Timeout, which is the number of seconds to wait
between when the phone starts ringing and the phone initiates call
forwarding on no answer. Range: 0 to 63. Default value: 20 (0x14,
20 seconds).
• Bits 28–29: First Key Repeat Interval, which specifies how long a user
must hold the Volume or the Navigation button up or down before the
desired change begins to repeat. Valid values: 0 (1 second), 1 (disable
repeat), 2 (2 seconds), and 3 (3 seconds). Default value: 0 (1 second).
• Bits 30–31: Subsequent Key Repeat Interval, which specifies the intervals
at which a change continues to repeat (after the First Key Repeat Interval)
when a user continues to hold the Volume or the Navigation button up or
down. Valid values: 0 (0.25 second), 1 (0.5 second), 2 (0.75 second), and
3 (1 second). Default value: 0 (0.25 second).
Value type: Bitmap.
Default value: 0x01418064