Auto-cut 300 xt – Tweco 300 XT Auto-Cut 480V User Manual
Page 48
Advertising
AUTO-CUT 300 XT
3-2�
INSTALLATION
Manual 0-5300
e. Repeat steps ‘b’ through ‘d’ until the system
no longer shuts down. Depending on the
length of the torch leads this sequence may
need to be done three to five times.
f. After the system stays operational allow the
pump to operate for ten minutes to properly
purge any air from the coolant lines before
using the system.
3. Re-fill the reservoir and re-install the filler cap.
NOTE
Circuitry in the power supply will generate a ‘Low
coolant’ message if the coolant level is too low.
Advertising