Tweco Tri-Arc Serie User Manual
Page 18
Advertising
4-4
5. Thread the incoming Compressed Air Line with a 3/8" pipe threaded fitting into the
Power and Air Connector. This connection should be wrench tight.
Figure 4-11: K-5
Figure 4-12: Tri-Arc
®
Series
Figure 4-13: K-5
Figure 4-14 Tri-Arc
®
Series
6. Slide the molded protective boot back over the power and air connection so that no
metal parts are protruding out of the protective boot. Operator needs to make sure the
boot stays in position over the connection to avoid accidental arcing to a grounded
work surface.
Figure 4-15: K-5
Figure 4-16: Tri-Arc
®
Series
7. The assembly is now ready to be used in your metal removal application.
Advertising