02 installation of wire spool, 02 installation of wire spool -2, Portafeed vs 212 – Tweco VS 212 PortaFeed User Manual
Page 28
PORTAFEED VS 212
INSTALLATION
3-2
Manual No. 0-4994
3.02 Installation Of Wire Spool
NOTE
The wire spool hub supplied with the unit
is provided for mounting a 44 pound (20
kg) spool of wire. Optional adapters are
available allowing a 10 (4.5 kg) or 15 (6.8
kg) pound spool of wire or a 14 (6.4 kg)
pound coil of wire to be used.
1. Remove the wire spool hub nut by turning
counterclockwise.
2. Slide the spool of wire over the wire spool hub.
3. Make sure that the alignment pin on the hub enters
the hole in the backside of the wire spool.
4. Replace the wire spool hub nut and turn clockwise
to a snug position.
NOTE
Install the welding wire spool so the wire
feeds from the bottom of the spool into
the input wire guide.
Wire Spool
Hub Nut
Alignment Pin
Wire Spool
Hub
Art # A-07195
1
2
3
4
Wire
Spool
Step
Step
Step
+
Figure 3-2: Wire Spool Installation