Tweco A 2000 Ultra-Feed - Manual (Page 24)

ULTRAFEED A 2000
3-4 May 1, 2006
3.08 Welding Gun Compatibility And
Installation
Refer to Figure 3-3.
The ULTRAFEED A 2000 wire feeder is designed to be
used with most welding guns. In some cases, a special
adapter may be required.
To install the welding gun, simply loosen the gun clamp
knob and insert the welding gun into the feedhead until it
stops. Tighten the gun clamp knob and connect the
welding gun control wires to the gun switch receptacle.
NOTE
Before inserting the welding gun into the
feedhead, make sure the gun clamp does not
extend into the feedhead; otherwise, the
welding gun cannot be properly inserted.
NOTE
Check for gas leaks. If leaking gas, gun is not
all the way into the feedhead.
Art # A-07266
Gun Clamp Knob
Gun Adapter
Figure 3-3: Welding Gun Installation