03 cleaning the welding power source, Transarc 170i – Tweco 170i Transarc User Manual
Page 59
Advertising
TRANSARC 170i
Manual 0-5281
5-5 POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
5.03 Cleaning the Welding Power Source
!
WARNING
There are dangerous voltage and power levels present inside this product. Do not attempt to open
or repair unless you are a qualified electrical tradesperson. Disconnect the Welding Power Source
from the Mains Supply Voltage before disassembling.
To clean the Welding Power Source, open the enclosure and use a vacuum cleaner to remove any accumulated
dirt, metal filings, slag and loose material.
5.04 Factory Reset Procedure
To perform a Factory Reset, press the Trigger Mode Button while turning on the mains power.
Figure 5-1
Advertising