Weldskill auto-darkening welding helmets – Tweco Cigweld WeldSkill Auto Darkening Welding Helmets User Manual
Page 15
WeldSkill Auto-Darkening Welding Helmets
14
February 29, 2012
SECTION 8:
Changing of Front Cover Lens
WARNING
Do Not Use the Welding Helmet without the Front Cover Lens installed correctly in place.
If the Front Cover Lens is broken, plainly worn, distorted or contaminated it should be replaced immediately with a genuine
Cigweld replacement part.
1. Removing the Front Cover Lens.
Remove the Front Cover Lens by pulling up the central part of
the lens (as pictured) and sliding one side at a time from
under the tabs.
2. Installing the Front Cover Lens.
Align the Front Cover Lens and place under the tabs (as
pictured) on one side that secure the Front Cover Lens in
place.
Pull up the Front Cover Lens in the centre and repeat for the
other side.
WARNING
Ensure that the Front Cover Lens is securely in place
before use.