Tweco FP-35A User Manual
Page 15
Advertising
Manual 0-4681
4-3
Operation
E. Typical Cutting Speeds
Cutting speeds vary according to torch output, the type of material being cut, and operator skill. Speeds
shown are typical for this cutting system using air plasma to cut mild steel, with output current at the
highest setting and the torch used in the Drag mode or standoff height indicated.
Unit
Standoff
Material
Thickness
FP-35A
Drag
(10GA) 0.135" ( 3mm)
94.7
2367
75.7
1893
FP-35A
Drag
(7GA) 0.179" (4.5mm)
57.0
1425
45.6
1140
FP-35A
1/8" (3mm)
1/4" (6mm)
36.3
908
29.1
727
FP-35A
1/8" (3mm)
3/8" (10mm)
15.3
383
12.3
307
FP-35A
1/8" (3mm)
1/2" (12mm)
9.7
242
7.7
193
Recommended Travel Speed
(imp , mm/m)
Maximum Travel Speed
(ipm , mm/m)
NOTE:
Drag or Drag mode refers to the torch tip being in contact with the work piece at all times.
Advertising