Valco Baby Buggster Bassinet - Manual (Page 2)

A
B
D
REMOVE THE FRONT
BUMPER BAR
FIGURE A
1. Press the locking button on the inside of
the bumper bar housing (1) and lift it out.
Repeat for the other side.
REMOVE THE STROLLER
FABRICS
FIGURE B
1. Disconnect the seat tethers at the rear of
the seat from the frame by pushing firmly
on the long side of the clip, forcing the
rivet head through the narrow channel (2).
Repeat for the other strap.
FIGURE C
1. Open each of the four flaps which cover
the zippers located along the inside length
of the stroller frame.
2. Lift the elastic ends of the zippers off
the securing rivet heads (3). HINT: Note
the location of each of these rivet heads
for when you will re-install your stroller
fabrics.
3. Unzip the fabrics (3) & (4) from the
stroller frame.
4. Slide the bottom of the fabrics from the
slot in the housing in the rear of the front
wheel swivel system.
BE SURE TO WRAP YOUR FABRICS AND STORE
THEM IN A COOL DRY PLACE.
INSTALLING THE BASSINET
ADAPTORS
FIGURE D
1. Pull the locking lever inward (5) and slide
the hinge cover (6) upward, toward you.
Repeat for the other side. Store in a safe
place as you will need to replace them
when you reinstall your stroller fabrics.
1
5
2
4
C
3
6