Valco Baby Buggster Bassinet - Manual (Page 3)

FIGURE E
1. Aligning the tracks at the rear of the
bassinet adaptor with those in the
uncovered hinge, slide the adaptor (7)
downward onto the hinge, until you feel it
secure in place. Repeat for the other side.
FIGURE F
1. Place the adaptor extension over the
bassinet adaptor (8) making sure that
the locking button (9) catches in the
adaptor hole. Repeat for the other side.
Ensure adaptors are locked firmly into
position. IMPORTANT: You may find these
extensions stored in the housings on each
side of the bassinet.
INSTALLING /REMOVING
YOUR BASSINET
FIGURE G
1. Standing at the side of the chassis, and
holding the bassinet at both sides by
the plastic hand holds, tilt the bassinet
slightly toward you.
2. Gently slide the bassinet into the chassis,
so that it is facing towards the handles.
Align the plastic housing on the side of the
bassinet (10) over the bassinet adaptor
on the chassis (11) that is closest to you.
3. “Line up” the other side of the bassinet
with the corresponding bassinet adaptor.
4. Press down gently on the bassinet and it
should slide into place.
FIGURE H
1. For greater security you can additionally
secure your bassinet to the frame by
sliding the locking strap “keyhole clip”
over the locking rivet head (12) and
pulling it firmly through the narrow
channel, locking it in place.
2. To remove your bassinet: If the locking
strap is engaged, reverse the procedure
outlined in Figure H No. 1.
3. Holding the bassinet by the plastic grips
at either side, simultaneously press the
two triggers located inside each grip.
4. Gently lift the bassinet from the frame.
F
H
G
7
9
8
12
E
10
11