Valco Baby Twin Latitude Peg Perego Adaptor - Manual (Page 2)

INsTALLINg yOUR PEg PEREgO
CAR sEAT ADAPTOR
FIgURE A
1. Begin preparing the Latitude stroller for the Car
seat Adaptor by removing the canopy (hoods) from the
stroller and reclining the seats to their fully reclined
position (detailed instructions in the Twin Latitude
stroller Instruction Manual).
2. Remove the bumper bar, (detailed instructions in the
Twin Latitude stroller Instruction Manual).
3. Remove the extra hood and Peg Perego Adaptor
Bar from the packaging and dispose of packaging
responsibly.
FIgURE B
4. Prepare the Hood for installation by rotating the
hood rods so they are aligned with the corresponding
connector pieces on the stroller frame (where the twin
hood was connected.) (1)
NOTE: ENsURE THAT THE HOOD Is PLACED OVER THE
LEFT sEAT OF THE sTROLLER (WHEN FACINg yOU).
5. simultaneously slide the hood rods onto the
corresponding raised pieces on the stroller frame and
lock into place. (2)
Figure C
6. Align the Adaptor Bar connector piece with the
corresponding raised piece on the outer frame of the
stroller.
NOTE: BE sURE THAT THE ADAPTOR BAR Is IN ITs
UPRIgHT POsITION By PULLINg THE sUPPORT BAR
AWAy FROM THE ADAPTOR FRAME.
7. slide the Adaptor onto the corresponding raised piece
and lock into place.
NOTE: ONLy ONE sIDE OF THE ADAPTOR WILL sLIDE
ONTO THE sTROLLER FRAME. THE ADAPTOR WILL NOT
BE CONNECTED TO THE MIDDLE FRAME.
Figure D
8. Locate the middle hood connector piece.
9. Unscrew the screw, washer and nut from the middle
piece.
A
Hood
Seat Reclined
Adaptor Bar
1
2
D
Front View
B
C