Valco Baby Twin Latitude Peg Perego Adaptor - Manual (Page 3)

NOTE: THE UNsCREWINg AND sCREWINg Is ONLy
PART OF THE INITIAL INsTALLATION PROCEss, AND
WILL NOT HAVE TO BE REPEATED WITH EACH UsE.
FIgURE E
10. Insert the remaining unattached adaptor bar into
the centre of the middle connector piece.
FIgURE F
11. Align the adaptor piece with the middle connector
piece and hood piece.
12. Insert the screw, and secure with the washer and
nut.
13. The Adaptor is now secured to the frame with the
support bar resting on the edge of the seat, above the
footrest.
FIgURE g
14. Adjust the footrest upwards.
To do so: Press the adjust button, and move the footrest
to the desired position. (3)
15. Located on the car seat adaptor are two sets of
tether straps. The first set (as shown in Figure G) rest on
the foot rest of the stroller. Adjust these straps so they
wrap underneath the foot rest of the stroller. (4)
16. secure by inserting the male clip into the female
end. Ensure these straps are as tight as possible.
17. The adaptor is now securely attached to your stroller.
you may readjust the footrest to suit your child.
FIgURE H
18. Position the Car seat so the infant is facing the
handlebar of the stroller.
19. Line the Car seat up with the adaptor bar so that
the Car seat rests on the adaptor bar when inserted.
F
E
Front View
Press
3
4
IMPORTANT WARNING: ALWAYS TEST THAT ALL
STRAPS ARE SECURELY ENGAGED BEFORE
USE.
g
H