VICI D-4-I-SH17-R - Manual (Page 16)

12
Pulser Module Installation
1. GC-17: The pulser module can usually be mounted on the bottom plate of
the GC, using existing holes. (Figure 6) If there is no room on the bottom
plate, mount the module on the top of the GC oven.
GC-2014: There is room for the pulser module in a compartment on the
right side (facing the instrument), at the back near the top. (Figure 7)
GC-2010: The best place is a space in the rear on the left hand side.
(facing the instrument). Two screws hold the vented cover in place.
(Figure 8)
2. Power to the pulser module is provided through the pulser power supply
(PN I-23569-1). Plug the 4-pin connector into the pulser module.
TO DETECTOR
PULSER MODULE
TO PULSER
POWER SUPPLY
OPTIONAL LOCATION FOR
PULSER MODULE
Figure 6: Mounting the pulser module in the GC-17
Installation