VICI Selectors (multiposition) Standard electric - Manual (Page 10)

 Actuator Modifications
4. Disconnect the motor from the board. (Refer to Drawing No. 22835 on
page 29.)
5. Loosen but do not remove the two 8-32 x 1-1/4" hex head (9/64) screws
which hold the boards to the gearbox. Remove the board/spacer assem-
bly as a unit, lifting it straight up to clear the thin metal encoder disc.
6. Removing the boards exposes the encoder disc, which is the component
that must be changed. Use the 9/64 hex driver to remove the screw and
washer which secure the disc, and then remove the disc, avoiding its
sharp edges. Handle the disc gently so it does not get bent.
�����������
��������
������
�����
����
����
����������
�����������
��������
������
��������
��������
�����
����
�����������������������������
�����������������������������
���������������������������
�����������������������������