VICI Selectors (multiposition) Standard electric - Manual (Page 18)


11. While holding the valve steady, firmly tighten the screw in the clamp
ring. The rotor should be properly positioned at the point of maximum
flow when the actuator is stepped to the next position.
Congratulations, the procedure is complete. It is a good idea to cycle the
valve through all its positions to be certain everything is functioning properly.
In some cases it is possible to do an additional check by simply looking down
the fitting detail and into the port as the valve is stepped from position to
position. If it is a valve which has a relatively short distance from the bottom
of the detail to the internal taper, the engraved “dimples” on the seal are
visible as they come into alignment with the port.
Consult the factory if additional help is needed.
����
�����
�����
��������
�����������
������
����
�����
����� ����
���� �����
����������������������������
�����������������������������
��������
��������
������
�����
�����
�������������
������ �����
������������������������������
�����������������������������
Valve Alignments