Waring WFP16SCD - Manual (Page 7)

12 13
OPERATING THE CONTROLS
• Plug the machine into an electrical outlet. The outlet must be
120V, 60Hz.
• There are three control buttons on the base unit.
The three controls are: ON
OFF
PULSE
How they work: ON: Press the ON button to start
the motor.
OFF: Press the OFF button to stop
the motor.
PULSE: To pulse the motor, press the
PULSE button down, then
release. The motor will run as
long as you hold the button
down; it stops when you
release the button.
HOW TO USE
Continuous use
For continuous processing, use the ON button which is located in
the middle.
Pulsing
• For rapid ON/OFF operation, use the PULSE. The motor runs as
long as you hold the button down; it stops when you release the
button.
• You control the duration of each pulse by the amount of time
you hold the button down. You control the frequency of pulses
by the rate at which you press the button.
• Pulsing gives you greater control over consistancy when
chopping, blending and mixing.
• Pulsing is also useful in processing hard foods. Pulse the food
a few times to break it up into smaller parts. Then proceed with
continuous use after the pieces are broken up and easier to
process.
the unit until the continuous-feed chute is properly assembled
with the cover.
To remove dicing assembly, first rotate dicing blade counter-
clockwise and lift up from the edges. Be careful not to touch
the blade when removing dicing assembly as the blades are
very sharp. Next lift the dicing grid. NOTE: Dicing assembly
(WFP16S13) is to be handwashed only. DO NOT PUT
DICING BLADE OR GRID IN DISHWASHER.
NEVER ATTEMPT TO START THE FOOD PROCESSOR
WITHOUT THE CHUTE AND COVER LOCKED INTO
POSITION.
• Insert the small food pusher into the large food pusher opening.
Now you are ready to insert the large pusher into the feed tube
opening.
• Once feed chute is assembled, place separate container under
the feed chute.
DISASSEMBLy OF CONTINUOUS- FEED
CHUTE PARTS
ALWAyS UNPLUG THE CORD BEFORE DISASSEMBLING.
• Turn the cover clockwise until the safety interlock tab on the
cover is disengaged from the safety interlock switch on the
chute, and the tabs are clear of the tabs on the cover.
• Remove the large food pusher from the feed tube. Remove the
small pusher from the large pusher.
• Remove the continuous-feed chute from the motor base. If the
chute is pointing in the 4-o’clock position, just lift it up. If not,
rotate clockwise to disengage the tabs on the bottom of the
chute platform (motor base) from the slots on the bottom of the
continuous-feed chute.
• Use caution removing accessory discs as the blades are
very sharp.