Winchester Repeating Arms 1200 (Historic Manual) - Manual (Page 3)

TO ASSEMBLE TRIGGER GROUP TO RECEIVER
1. Be sure hammer is cocked in trigger group as
i I I ustrated.
2. Be sure that the slide arms are in the cut outs
on the bottom of the bolt assembly.
3. Assemble trigger group to the receiver by carefully
working the front end of the group into the slots
at the front end of receiver. Gently push rear end of
trigger group down into position. If the front end
of the trigger group is correctly positioned, this will
require little effort. DO NOT FORCE.
4. Insert trigger guard pin from right to left and
push in flush with side of receiver.
10