LaMotte WaterLink Spin - Manual (Page 6)

6
 PACKAGING & RETURNS
Experienced packaging personnel at LaMotte Company assure adequate
protection against normal hazards encountered in transportation of shipments.
After the product leaves the manufacturer, all responsibility for its safe delivery
is assured by the transportation company. Damage claims must be fi led
immediately with the transportation company to receive compensation for
damaged goods.
Should it be necessary to return the instrument for repair or servicing, pack
the instrument carefully in a suitable container with adequate packing material.
A return authorization number must be obtained from LaMotte Company by
calling 1-800-344-3100, ext. 2 or emailing [email protected]. Attach a letter
with the authorization number to the shipping carton which describes the
kind of trouble experienced. This valuable information will enable the service
department to make the required repairs more effi ciently.
 GENERAL PRECAUTIONS
Read the instruction manual before attempting to set up or use the instrument.
Failure to do so could result in personal injury or damage to the meter.
The WaterLink Spin should not be stored or used in a damp or corrosive
environment. Care should be taken to prevent water or reagents from entering
the photometer chamber. Wet disks should never be put into the photometer
chamber.
 SAFETY PRECAUTIONS
Read the safety precautions on the labels of all reagent containers and
packaging prior to use. Material Safety Data Sheets (MSDS) can be found at
www.lamotte.com . Additional emergency information for all LaMotte reagents
is available 24 hours a day from the Poison Control Center listed in the front
of the phone book or by contacting the 24 hour emergency line for ChemTel
at 1-800-255-3924 (USA, Canada, Puerto Rico). For locations outside of the
North American continent call 813-248-0585 collect.
 LIMITS OF LIABILITY
Under no circumstances shall LaMotte Company be liable for loss of life,
property, profi ts, or other damages incurred through the use or misuse of its
products.
 CE COMPLIANCE
The WaterLink Spin meter has been independently tested and has earned the
European CE Mark of compliance for electromagnetic compatibility and safety.
To view certifi cates of compliance, go to the LaMotte website at www.lamotte.
com.
NOTE: The device complies to the product specifi cations for the Low Voltage
Directive.