Step 2: setting up shared folders, Step 3: configure the smm100 with digilinx, Step 3: configure the smm100 with digilin x – ClearOne DigiLinX User Manual
Page 107
DigiLinX Installation and Design Guide
14-4
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Step 2: Setting up Shared Folders
For music on a hard drive to be recognized by the SMM100, the folder must be shared.
This is a process where a folder on a computer or Network Accessible Storage (NAS)
drive is set so that it is accessible by other computers on the network.
NOTE:
The time it takes for the SMM100 to recognize music on a new shared folder, catalog
its folder, and make that information available to the DigiLinX network is not instantaneous.
Please wait up to 15 minutes on the first configuration attempt to ensure your new shared
folder is recognized by the SMM100 and that music files are properly identified.
Since the procedures for setting up shared folders vary from operating system to
operating system, refer to your operating system manual for procedures on setting up
shared folders.
For each computer hosting music, a unique shared folder name must be applied.
If more than one computer is hosting music on the network, complete this procedure
for each computer. Each shared folder name must be unique.
Step 3: Configure the SMM100 with DigiLinX
The SMM100 ships with an IP address of 10.15.1.25. This address can be changed
from DigiLinX Dealer Setup. For further information on configuring the SMM100,
refer to the DigiLinX Dealer Setup Manual on the NetStreams
www.netstreams.com
) on the Dealer Documents page.