ClearOne Connect Dante - Manual (Page 4)

CONNECT NETwOrk BridgEs QuiCk-sTarT guidE
4 5
upDATE THE CONvErGE prO FirmwArE
After updating your CONVERGE Console software, you must update your
CONVERGE firmware to version 4.3 or higher. All CONNECT network
audio bridges are not recognized by systems running older versions and
the 4.3.X versions offer significant upgrades from previous versions.
ClearOne strongly encourages users to upgrade all firmware to the latest
release version. Instructions for updating from version 1.X 2.X and 3X are
detailed later in this document.
NOTE: Save the CONVERGE Console site file before performing
any firmware upgrade.
1. Download the 4.3.X firmware file to the stack of units.
2. The units will default and reboot after the download of 4.3.X
firmware.
3. Units are fully upgraded.
4. Verify units have been upgraded by checking the firmware version
on the front panel.
Reconnect all E-bus cables, if needed, to complete the stack of units.
Device ID Rotary
Selection Switch
SET THE DEviCE iD
Set each CONNECT unit to a unique ID using the Device ID selector
rotary switch on the back of the unit. (Range 0-7) Each CONNECT unit in
any site needs a unique Device ID. Only 8 units are allowed in any site.