Cisco ONS 15600 - Manual (Page 7)

11-7
Cisco ONS 15600 Procedure Guide, R5.0
February 2008
Chapter 11 Change Card Settings
NTP-E66 Modify Line and Status Thresholds for Optical Ports
SD BER Sets the signal degrade bit error rate • 1E-5
• 1E-6
• 1E-7 (default)
• 1E-8
• 1E-9
Provides Sync Indicates that the port has been
provisioned as a network element timing
reference on another node (ONS 15600,
ONS 15454, or ONS 15327) Read-only
• Yes (checked)
• No (unchecked)
Send Do Not
Use When checked, sends a DUS (do not use)
message on the S1 byte • Yes (checked)
• No (unchecked; default)
BLSR Ext.
Byte Chosen extended byte carries information
that governs BLSR protection switches. • K3
• Z2
• E2
• F1
Admin State Sets the port service state unless network
conditions prevent the change. • IS—Puts the port in-service. The
port service state changes to IS-NR.
• IS,AINS (default)—Puts the port in
automatic in-service. The port
service state changes to
OOS-AU,AINS.
• OOS,DSBLD—Removes the port
from service and disables it. The port
service state changes to
OOS-MA,DSBLD.
• OOS,MT—Removes the port from
service for maintenance. The port
service state changes to
OOS-MA,MT.
AINS Soak Sets the automatic in-service soak period. Duration of valid input signal, in hh.mm
format, after which the card becomes in
service (IS) automatically (0 to 48 hours,
in 15-minute increments).
Type Defines the port as SONET or SDH.
Enable Sync Msg and Send Do Not Use
must be disabled before the port can be
set to SDH. • SONET (default)
• SDH
Table 11-2 OC-N Card Line Settings (continued)
Heading Description Options