Monarch Instrument Android Application - Manual (Page 5)

RFID Logger Android App User Guide Page 5
5. DATA TAB
Pressing the DATA TAB will cause the application to read ALL the data
from the logger if it has not already done so. The logger needs to be held
in the NFC antenna area for the duration of the read which will be around
8 to 10 seconds. Once reading starts the “Reading” window pops up (left)
until the data is read and processed. The data is then displayed in tabular
format as shown below.
There is a data overview area which shows the Average, Maximum and
Minimum of all the data. In the case below this is shown for both
channels, Temperature and Humidity.
The data table has the sample number followed by the date/time stamp
and the actual data value. Any data point which exceeded an alarm is
shown in red. In the figure below there are two columns of data –
temperature and humidity as this is from a dual channel logger.
Data can be scrolled by using your finger to swipe the
tabular data up or down. Once data starts to scroll a cursor
appears. You can drag the cursor to accelerate the flow of
data.
Data can be saved to the device memory or SD card by
tapping the SAVE DATA icon. The file manager will pop up
and can be used to navigate to an existing folder, create a
new folder and name the file to be saved. The file must
have a .dat file type extension.
Data can be emailed to a remote location by tapping the
EMAIL DATA icon. The email will contain an attachment
which is the data file named “serial number unit tag”.dat
where serial number and unit tag are from the logger. This
file can be read on a PC using the available PC software.
Return to the
Summary Tab to proceed to logger
configuration.
DATA TAB