Monarch Instrument Android Application - Manual (Page 8)

RFID Logger Android App User Guide Page 8
7. CONFIGURATION
The logger can be configured for use by pressing the CONFIG LOGGER button on the Summary Tab .
This will take you to the configuration page shown below. Note that on a phone you will need to use
your finger to drag the screen so you can see the lower half of the page.
The Configuration window is used to set up the logger for operation. The configuration options depend
on what type of logger you are using. These examples are for a Dual Channel Temperature/Humidity
device.
If you do not need to make any changes to the way the logger operates you can simply write the
configuration to the logger as it was read. This will restart the logger with the existing configuration.
Notes:

Writing the configuration to the logger will restart it, this will CLEAR ALL DATA within the logger
and start over. If you read the logger part way through a recording and wish to continue with
that recording
DO NOT WRITE the configuration to the logger.

You can write the same configuration to more than one logger of the same type. You cannot
write the configuration to a different type of logger.

CONFIGURATION WINDOW