Wheatheart Self-Propelled Auger Kit (Wheatheart R Series) - Manual (Page 35)

W HEATHEART - S ELF -P ROPELLED A UGER K IT 5. O PERATION
W HEATHEART BH & R S ERIES 5.1. S TART -U P
30761 R0 35
5. Operation
Operators must observe safety procedures at all times and follow the pre-opera-
tional checklist before each start-up.
P RE -O PERATION C HECKLIST
Before operating each time, the operator must follow the checklist, which should
confirm the following:
• Follow the service schedule.
• Check hydraulic system oil level.
• Ensure that all hydraulic lines are free from damage, and that all fittings
are tight.
• Visually inspect the unit for damage to components. Replace or repair any
damaged or questionable parts.
• Check that all guards are installed, secured, and functioning as intended.
• Check the worksite and clean up the area, if needed.
• Ensure that the auger is securely attached to the towing vehicle or tractor.
5.1. START-UP
Although there are no operational restrictions on the machine when used for the
first time, it is recommended that the following mechanical items be checked:
B
EFORE
S
TARTING
:
• Read power unit operational manual.
• Inspect hydraulic hose fittings for leaks. Tighten if necessary, and replace
worn or damaged hoses.
• Inspect hydraulic mount bolts for tightness.
D URING THE F IRST F EW M INUTES :
• Ensure unit is running properly.
• Some air may be trapped in the hydraulic system; slowly activate hydrau-
lic control valves to ensure all air is out of the system.
Warning: Before continuing, ensure you have read and understand the relevant information
in the safety section. Safety information is provided to help prevent serious injury, death, or
property damage.
WARNING
Shut off and remove key or lock out power
source before inspecting or servicing the
machine.