Campbell Hausfeld IN734600AV - Manual (Page 5)

5
Operating Instructions
SB660000
www.chpower.com
Operating Instructions
(Continued)
OPERATIONAL MODE - SINGLE CYCLE
Always know the
operational mode of
the tool before using. Failure to know
the operational mode could result in
death or serious personal injury.
This tool requires the trigger to be
pulled each time a nail is driven. The
nailer can be actuated by depressing the
Work Contact Element (WCE) against
the work surface followed by pulling
the trigger.
The trigger must be released to reset
the tool before another nail can be
driven.
WORK CONTACT ELEMENT (WCE)
Check the operation
of the Work Contact
Element (WCE) trip mechanism before
each use. The WCE must move freely
without binding through its entire
travel distance. The WCE spring must
return the WCE to its fully extended
position after being depressed. Do
not operate the nailer if the WCE trip
mechanism is not operating properly.
Personal injury may occur.
1. Disconnect the air
supply from the tool.
2. Remove all fasteners
from the magazine
(see Loading/
Unloading).
3. Make sure the trigger
and WCE move freely
up and down without
sticking or binding.
4. Reconnect air supply
to the tool.
5. Depress the WCE
against the work
surface without
pulling the trigger.
The tool MUST NoT
opERATE. Do not use the tool if it
operates without pulling the trigger.
Personal injury may result.
6. Remove the tool from
the work surface.
The WCE must return
to its original down
position. The tool
MUST NoT opERATE. Do not use the
tool if it operates while lifted from
the work surface. Personal injury
may result.
7. Pull the
trigger
and
depress
the WCE
against
the work surface. The tool MUST
NoT opERATE.
8. Depress
the WCE
against
the work
surface.
Pull the
trigger. The tool MUST opERATE.
An improperly
functioning tool
must not be used. Do not actuate the
tool unless the tool is placed firmly
against the work piece.
LOADING/UNLOADING THE NAILER
1. Always disconnect the tool from the
air supply before loading fasteners.
2. Push
down on
the latch
button.
Pull back
on the
magazine
cover.
3a. For 18 gauge nails, insert a stick
of Campbell Hausfeld nails or
equivalent (see “Fasteners” section)
into the magazine against the
ribs. Make sure the pointed ends
of the fasteners are resting on the
bottom ledge of the magazine when
loading. Make sure the nails are not
dirty or damaged.
3b. For 16 gauge nails, insert the nail
points down into the slot next to the
rail.
3c. For staples, load a clip of staples
with the crowns straddling the
magazine rail.
4. Push the magazine cover forward
until latch button pops up.
5. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except that you must disconnect the
air supply before unloading.
Latch
Button
Magazine Rail
Magazine Rail