Amico AHM Monitor Arms (Adjustable Height) - Manual (Page 21)

www.amico.com 18
Rotation (Monitor Head Side to Side)
WARNING: DO NOT adjust the rotation tension bolt. It will disassemble
from the arm. If there are any problems associated with the monitor head
please refer to the Troubleshooting section on pages 24-26, or contact Amico
Accessories.
(1-877-AMICO-XS)
1. The mounted device rotates at the front of the arm. To rotate the device,
push the corners of the device or the head while holding the AHM in place.
(Figure 1)
Section 4: Adjustments
(Figure 1)
Head Rotated
Portrait and Landscape Adjustment
NOTE: It is recommended to make the adjustments with the monitor mounted.
1. To adjust the orientation, turn the monitor. The monitor can turn up to 135 degrees left or right. The stopper is
positioned so that it cannot rotate beyond 135 degrees. (Figure 1)
2. To adjust the tension of the portrait and landscape feature for VESA 75 plate, the monitor must be removed from
the Monitor Head. Remove the four VESA 75 screws from the monitor. Turn the Rotational Tension Bolt (Figure 1) in
the center of the VESA adapter clockwise to tighten the tension. Turn counterclockwise to loosen the tension. After
tension is adjusted, remount the monitor. (Refer to page 10)
3. To adjust the tension of the portrait and landscape feature for VESA 100 plate, the monitor must be removed from
the Monitor Head. Remove the four inner screws that secure the VESA 100 plate to the VESA 75 plate. There is no
need to remove the VESA 100 plate from the monitor. Turn the Rotational Tension Bolt (Figure 1) in the center of
the VESA adapter clockwise to tighten the tension. Turn counterclockwise to loosen the tension. After tension is
adjusted, remount the monitor. (Refer to page 10)
(Figure 1)
Rotational Tension Bolt