B&G Network Autopilot User Manual
Page 51
4 - 3
•
All cables should be routed at least 1m / 3ft from cables or
components that carry or generate high currents, e.g. alternators,
starter motors and cabling, trim-tab cables, etc.
•
To minimise interference avoid routing Network cables alongside
high power radio or Radar cables, allow 3m/10ft spacing, or within
1m/3ft of engine starter motors and cables and other cables carrying
heavy current.
•
To prevent damage to cabling always secure in position using cable
clips or tie-wraps. Where cables pass through bulkheads always
protect the cable from chafing by fitting grommets.
•
Do not allow cables to rest in bilges where prolonged immersion in
water, fuel, etc. could occur.
•
Always fit splash covers and lids on processors, computer units and
junctions boxes, where supplied.