B&G Network Autopilot - Manual (Page 68)

4 - 20
NON-B&G PADDLEWHEEL CONNECTION
Using a non-B&G speed sensor (SEE PAGE 4-21).
The speed sensor must have a speed signal output from a hall-effect
device giving positive pulses of 12v maximum.
1. Locate the cable from the speed sensor to the instrument input.
2. Cut cable (if necessary) and insert a junction box (B&G part no. 288-
00-001). Connect like colour to like colour.
3. Use a length of 2-core screened cable (B&G part no. 135-0B-098
9m/29.5ft) to connect the speed signal and ground of the paddle
sensor to the speed input of the ACP computer unit.
4. Calibrate the speed input in accordance with the instructions given
in the COMMISSIONING (5-30) section of this manual.