Baseline Systems FreeWave Ethernet Radio - Manual (Page 33)

User Manual and Reference Guide
LUM0024AB Rev A
Each page or tab contains parameters that apply to the same area of functionality. For example, to setup a
serial port, you can access all the parameters for the first serial port in the Serial Setup 1 page.
Page Used To
Status View all device status information. For more information, see "Viewing
Transceiver Status and Statistics" on page 85.
IP Setup Setup the IP address, Subnet Mask, and Default Gateway of the radio.
Check with your Network Administrator before adjusting these settings.
Many of these settings are also available through Basic IP Setup in
HyperTerminal and the Discovery Server. For more information, see "IP
and Network Communication Settings" on page 31.
Serial Setup 1 and
Serial Setup 2 Set the port numbers and data settings for each serial port. These settings
need to match the device to which each port is connected. For more
information, see "Serial Port Settings" on page 39.
Radio Setup Set the transceiver’s Operation Mode, Transmission Characteristics,
Multipoint Parameters, and the Call Book. For more information, "Radio
Settings" on page 51.
Security Set the RADIUS server authentication, MAC filtering, and the AES
Encryption information. For more information, "Security Settings" on page
71.
SNMP Set the SNMP management features of the transceiver. The transceiver
supports SNMP versions 1, 2, and 3. All of the SNMP-manageable
objects for FreeWave's radios are contained in a single MIB file:
FREEWAVE-TECHNOLOGIES-MIB. This file is available from
FreeWave upon request. For more information, "SNMP Settings" on page
77.
17