Baseline Systems FreeWave Ethernet Radio - Manual (Page 88)

FGR2-PE Wirelss Data Transceiver
LUM0024AB Rev A
each time a firmware upgrade is initiated, the system makes an entry in the log.
The system log time is pulled from the NTP server, if the NTP Client setting in the IP Setup parameters on
page 33
1. Access the transceiver's configuration Web pages.
For more information, see "Accessing Configuration Web Pages" on page 19.
2. In the Pages menu on the left side, click Security to display the Security page.
3. In the Logging section at the bottom of the page, click View Log. The log file, formatted similar to
the following, displays.
Security Parameter Reference
This section contains the following information as it applies to the security parameters that you can set for the
transceivers described in this document.
parameter name (as you see it in Tool Suite)
Web Parameter: The name of the field as it appears in the configuration Web pages.
Network Type: Point-to-Point, Point-to-MultiPoint, or Both
Default Setting: The factory default setting for the parameter.
Options: The options to which the parameter can be set.
Description: A description of what the parameter is and how it applies to the transceiver in
your network.
The parameters are listed in alphabetical order by their Tool Suite field name.
AES Encryption Key
Note: The encryption key must be the same on every transceiver in the FreeWave
network.
Web Parameter Key in the AES Encryption section of the Security page.
Network Type: Both
Default Setting: Blank
72