Basement Watchdog Big Combo - Manual (Page 14)

Page 13
Terminals corroded or battery defective
Clean terminals or replace battery
Replace with 20 amp auto fuse
If fuse blows again, replace pump
Add distilled water to battery. If using a
maintenance free battery attach fluid sensor
to the positive post of the battery
Pump was activated
Check main pump for failure
Check the circuit breaker
Make sure charger is plugged into wall & controller
If power is on, replace the charger
Battery
Fuse
Water
Pump
Power
Warning What to do
Press and hold
for 1 second to
test or reset alarm
Press and hold for 5
seconds to silence any
alarm for 24 hours
Charging
System
Operating
N.O.
N.C.
Common
Remote
Connection ction
Replacement Parts List
Description Part No.
1/2 HP AC sump pump BW1050-GL
Caged dual float switch with piggyback controller BWC2
Backup pump 1011002
Backup control unit BWSP-A
“Y” PVC pipe fitting 1120007
Support bracket for backup pump 1121006
Battery cap with hole for the fluid sensor 1125000
Charger for backup pump 1015001
Backup dual float switch 1020009
Backup pump locking screw (#12 x 1/2” pan head)* 1100018
1-1/4” check valve for backup pump*
1141000
1-1/2” check valve for primary pump* 1141001
No-hub stainless steel connectors* 1142000
1-1/2” rubber union* 1142001
2” hose clamp* 1122002
Cable tie* 1122000
*Stock items available in plumbing department
Call 800-991-0466, option 3 to order parts.
BOTTOM VIEW
SIDE VIEW