BE Pressure supply 2500 Watt Inverters Generators - Manual (Page 15)

15
starting your inverter generator
WARNINg
Before starting the engine, disconnect any load.
The right choke position is the key to starting the motor. You may have to
practice a few times to use the choke correctly.
Position the choke completely to the right to restart a hot motor.
Position the choke about halfway to restart a warm motor.
1. Turn the fuel cap lever to the ON position.
Air Flow Knob
2. Set the fuel valve in the “ON” –position.
3. To start a cold motor push the choke lever all the way to the left. To
restart a hot motor set the choke lever halfway.
1）OIL WARNING SYSTEM
When the oil level falls below the lower level, the engine stops automatically.
Unless you refill with oil, the engine will not start again.
2）ENGINE SWITCH
The engine switch controls the ignition system.
①
“ON”(run)
Ignition circuit is switched on. The engine can be started.
②
“OFF”(stop)
Ignition circuit is switched off. The engine will not run.
3）ECONOMY CONTROL SWITCH
2
1
When the economy control switch is turned “ON”, the economy control unit
control the engine speed according to the connected load. The results are
better fuel connection and less noise.
4）DC CIRCUIT PROTECTOR
The DC circuit protector turns off automatically when the load exceeds the
generator rated output.
2
1
CAUTION: ����������������������
z
Reduce the load to within specified generator rated output if the DC circuit
protector turn off.
���������������������������
5）FUEL TANK CAP AIR VENTKNOB
OF
F
ON
OFF ON
The fuel tank cap is provided with an air vent knob to stop fuel flow. The air vent
knob must be turned 1 turn counterclockwise from the tigened position. This will
allow fuel to flow to the carburetor and the engine to run.
When the engine is not in use, tigten the air vent knob clockwise until it is
finger-tight to stop fuel flow.
4
ON
Starting Your Inverter generator
I2500_3500 Inverter Generator Manual_2011.indd 15 18/10/2011 2:03:48 PM