BE Pressure supply 2500 Watt Inverters Generators - Manual (Page 28)

28
maintenance
Spark Plug Servicing
Please use high quality authentic spark plug.
To ensure proper engine operation, the spark plug must be properly
gapped and free of deposits
1. Remove the bolts on the top maintenance cover and the cover.
2. Take out the ignition coil rubber boot.
3. Remove the spark plug with spark plug wrench.
Spark Plug Wrench
Screwdriver
Insert the screwdriver into the hole of the spark plug wrench
and remove the spark plug.
CAUTION: ����������������������
1
The engine should never run without the element; excessive piston and/or
cylinder wear may result.
���������������������������
4）CLEANING AND ADJUSTING SPARK PLUG
1. Remove the cover.
2. Check for discoloration and remove the carbon.
3. Check the spark plug type and gap.
4. Install the spark plug.
5. Install the cover
5）FUEL TANK FILTER
1. Remove the fuel tank cap and filter.
2. Clean the filter with solvent. If damaged, replace.
3. Wipe the filter and insert it.
! WARNING ������������
z
Be sure the tank cap is tightened securely.
�����������������
6）MUFFLER SCREEN
! WARNING ���������������������
z
The engine and muffler will be very hot after the engine has been run.
z Avoid touching the engine and muffler while they are still hot with any part
of your body or clothing during inspection or repair.
��������������������������
1. Remove the cover.
2. Remove the muffler screen.
3. Use the flathead screw driver to pry the spark arrester out from the muffler
Standard electrode color: Tan Color
Standard Spark Plug: CR4HSB (NGK)
Spark Plug Gap: 0.6-0.7 mm (0.024-0.028 in)
11
I2500_3500 Inverter Generator Manual_2011.indd 28 18/10/2011 2:03:54 PM