Bio-Rad High-Throughput Dodeca™ Gel Stainers - Manual (Page 8)

2.2 Unit Assembly
2.2.1 Prior to assembly and use, wash the Dodeca stainer components (solution
tank, staining trays, and shaking rack) with a non-scratch pad and mild deter-
gent followed by a complete rinse with distilled water. For additional main-
tenance guidelines and chemical compatibility information see section 6,
pages 14-15.
2.2.2 Place the Dodeca stainer on a level surface in a convenient location and
near a grounded electrical outlet. Position the Dodeca stainer so that the drain
ports in the solution tank are accessible. Proper location and position of the
tank is important, since once the tank is filled and in operation it should not
be moved.
2.2.3 Attach the shaker motor to the lid, by tightening the black thumbscrews.
Position the shaker motor so the small hook at the bottom and the plug
inlet at the top are facing the opposite direction from the reagent access
door.
2.2.4 Assembling the drainage system.
a. Remove the stopcocks and tubing from the bag.
b. Attach the ends of the short piece of tubing to the drain port fittings at
the base of the solution tank.
c. Add the white clamps over the short piece of tubing and drain port
fitting. Tighten the clamp to ensure a complete seal to prevent leaks.
Note: It may be easier to use pliers to tighten the white clamps.
d. Ensure the long piece of tubing reaches your desired receptacle/
reservoir.
e. Make sure the stopcocks are in the closed position prior to pouring in
any solutions.
5