Bio-Rad Experion DNA Analysis Kits - Manual (Page 10)

2 Technical Support: 1-800-424-6723 • www.bio-rad.com
Please note the following when removing the contents from each shipping box:
• Carefully lift the electrophoresis station (Figure 2) by grasping the underside of the unit (between
the green feet) and the top of the unit
Fig. 2. The Experion automated electrophoresis station.
• Remove all instruments from the protective plastic bags and inspect for any external damage. If
any part is missing or damaged, contact Bio-Rad Laboratories immediately
• Remove the plastic film (sticky protective layer of foam) from the green lids of the
electrophoresis and priming stations
1.3 Packing List Verification Software Packages
The Validation kit (catalog #700-7051) and the Security Edition software (catalog #700-7052) are
available separately. Both kits provide access to the validation menus of the Experion 3.0
software. Only the Security Edition kit allows access to the security features necessary for
compliance with U.S. FDA 21 CFR part 11. Both kits contain:
A plastic box containing 3 Experion test chips:
• Focus chip
• Conductivity chip
• Current chip
Hardware protection key (HPK) or dongle
Quick Guide containing specific password information
This instruction manual
Confirm receipt of each component and that there is no apparent damage. Fill in date received on
sticker on lid of Experion Validation kit containing the three test chips. Please report any damage at
once to Bio-Rad Technical Support.
Green lid
Lid release latch
LED power status
Power button
Green rubber feet