Bio-Rad Bio-Plex Data Pro™ Software - Manual (Page 28)

Bio-Plex Data Pro Software User Guide | About the Sample and Results Tables
24
About the Sample and Results Tables
The Sample and Results tables are synchronized, so changes you make to
one table are immediately reflected in the other. For example:
• Filtering data from one table filters it from the other.
• Sorting data in one table sorts it in the same order in the other.
• Adding a column of data in one table adds it to the other.
• Changing the order of the columns in one table changes the
column order in the other.
Filtering Data
Data can be included or excluded from the project dynamically. This is
referred to as filtering. You can choose the types of samples being used in
your analysis at any time by using the filter tools. These filters are available in
most views throughout the software. All filters apply across the entire project.
For example, filter settings you apply to the Sample table are reflected in the
Results table and Perform Analysis/Create Charts view. They can be cleared
at any time using the Clear All Analysis Filters command.
Filtering Data in the Sample and Results
Tables
Contents of each column, including custom columns, can be filtered using the
drop-down list in its column heading. By default, all rows are included.
Note: Filters cannot be applied to the Multi Analyte table in the
View Results/View Heat Map view.