Cortelco Colleague 2211 - Manual (Page 10)

T
ELEPHONE
F
EATURES
TONE DIALING
This unit is capable of only DTMF dialing. This phone is not compatible with pulse dialing.
RECEIVING A PHONE CALL
1.
Be sure the RINGER switch is set to the HI or LOW position.
2. When the phone rings and the caller’s information shows on the display window
(refer to Using the Caller ID Function), lift the handset or press the SPEAKER-
PHONE button and begin your conversation.
3. Set the Ringer switch to the OFF position when you do not want to be interrupted
by the phone ringing. Remember to set the ringer switch back to Hi or Low when
you want to receive calls again.
PLACING A PHONE CALL
1.
Lift the handset or press the SPEAKERPHONE button and wait for a dial tone.
2. Dial the telephone number you wish to call. The number will appear on the display
window.
SPEAKERPHONE BUTTON
1.
Receiving Incoming Calls
a.
When the phone rings and the caller’s information shows on the display
window (refer to Using the Caller ID Function), press and release the
Speakerphone button and talk normally into the built-in microphone from a
distance of 5-6 inches.
b. You can adjust the volume of the caller’s voice by sliding the VOLUME
CONTROL on the right side of the phone.
c. After the conversation has finished, press the SPEAKERPHONE button to
hang up.
2. To Make A Call
a.
Press and release the SPEAKERPHONE button.
b. When you hear a dial tone, dial the number or press the auto memory
button just as you would on any other push-button telephone. The number
will appear on the display window.
7