Chief Manufacturing KSA-1020 - Manual (Page 9)

Installation Instructions KSA-1020
9
Figure 13
Mounting CPU to Wall
CAUTION: Overtightening screws may cause wall bracket
to compress into soft wall surface resulting in difficult mount
installation.
1. Ensure bracket flag is in the open position. (See Figure 2)
2. Insert mounting buttons into the four large mounting holes
on the bracket. (See Figure )
Figure 14
3. Move flag to closed position in order to fully secure mount
to bracket. (See Figure 15)
Figure 15
Desk Mount Installation
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the desk to which this component is attached can
support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
NOTE: The following instructions are for mounting with full
360° swivel capability for easy cord access. If this
capability is not desired, connect mounting bracket
using two screws as demonstrated in the wall mounting
instructions.
1. Determine location for mount keeping in mind CPU size and
safety requirements.
2. Using bracket and bearing (D) as a template, mark and drill
one 17/64" diameter pilot hole through underside of desk at
desired mounting location. Ensure entire mount will clear
the outer edge of desk. (See Figure 16)
Steel Stud
Drywall
Anchor Metal Channel
Mounting Bracket
(SIDE VIEW)
(E) x 2
12
13
2
(Flag in closed position)
3