Yealink RT10 - Manual (Page 2)

www.yealink.com
Introduction
Multiple Repeaters
DECT Repeater RT10 User Guide
Yealink DECT repeater RT10 is designed in accordance with Digital Enhanced Cordless
Telecommunication (DECT) standard. It can be deployed to extend the range of the
W52P IP DECT phone to cover areas where reception was previously not available. All
the usual handset functions are supported by the base station in the extended radio
range. The repeater, base station and cordless handset employ wireless connection.
Signals are exchanged without acoustical and visual differences.
Up to 6 repeaters can be registered to one base station to extend available reception
range for all registered handsets. All repeaters must be installed within the base station
coverage area (up to 300m in unobstructed outdoor areas and up to 50m inside
buildings), as shown in the figure below. It is not possible to install the repeaters in series
or “daisy-chain”.
The maximum number of handsets that can be registered to your base station is not
affected by the repeater. The repeater can be used to extend the coverage range in all
directions, allowing several floors to be covered. The automatic handover process is
seamless.
If the repeater is placed correctly (overlapping the coverage area of the base station),
the handsets can move freely within the total coverage area while on a call.
50m/300m
LED Indication Operation
Red Steady on Registered to base station, ready for use.
Attempting handset connection. Shortly flashes
To connect the power for the repeater:
To install the repeater using the supplied screw:
Installation
1. Connect the DC plug on the power adapter to the DC jack on the repeater.
2. Connect the other end of the power adapter to the AC outlet.
Hook
Wall
Wall Mount
Insert the screw into
the screw anchor.
Screw anchor is used to fix
the screw on concrete wall.
Red