Yealink dect repeater rt10 user guide-4.pdf, Verification tone – Yealink RT10 User Manual
Page 4
www.yealink.com
The flow diagrams of these two registration methods are shown below:
Auto Registration
Manual Registration
Base Station
Long press paging
key
Repeater
LED stays on
Repeater
Switch on
Repeater
LED flashes
Ready for use
Repeater
Switch off
Handset
Enable repeater mode
Base Station
Switch on
1. Switch off the repeater (disconnect the power adapter).
2. Switch it on for 1 to 5 seconds and switch it off again.
3. Switch it on again. The LED indicator on the repeater flashes slowly.
4. Switch it off again.
5. Switch it on again.
The verification tone is then activated.
To find the best possible location for the repeater, you may need to try various locations.
Place a call and walk around with the handset to determine the base station’s coverage
area. The verification tone allows you to easily check the extent of the repeater’s
coverage area. The tone is audible on the handset during a call.
Verification Tone
To activate the verification tone on the repeater:
Place a call using the handset to check whether the handset is working in the extended
area of the repeater. If the call is successfully handled by the repeater, you can hear the
verification tone from the handset every few seconds.
To deactivate the verification tone, repeat the above steps.
DECT Repeater RT10 User Guide
Handset
Enable repeater mode
Base Station
Switch on
Ready for use
Base Station
Set password to 0000
Repeater
Switch on (1-5s) and
off
Repeater
LED flashes without
interruptions
Handset
Dial out #*9
Base Station
Handset
Press number (2-7)
and * key
Hang up
Repeater
LED stays on
Long press paging
key
Repeater
Switch on again
No
Repeater
LED flashes with
interruptions
Handset
Re-register to base
station
Repeater
LED flashes without
interruptions
Keep a minimum of 10 meters between multiple repeaters to avoid coverage areas
overlapping.
Note: The LED indicator remains on constantly after the repeater has been switched on. If the LED
flashes, the repeater is too far away from the base station or reception is hindered by obstacles.