Display assembly, Removing the display assembly – Dell Latitude D620 User Manual
Page 12
Back to Contents Page
Display Assembly
Dell™ Latitude™ D620 Service Manual
Removing the Display Assembly
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Remove the keyboard (see
Keyboard
).
4.
Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.
5.
Disconnect the antenna cable(s).
6.
Carefully remove the antenna cable and the display cables from their routing guides.
7.
Close the display.
8.
Turn the computer upside-down with the back of the computer facing you.
9.
From the bottom of the computer, remove the two M2.5 x 8-mm screws labeled "D."
10.
From the back of the computer, remove the two M2.5 x 8-mm screws.
11.
Turn the computer right-side up and open the display.
CAUTION:
Before performing the following procedures, follow the safety instructions in the Product Information Guide.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.