Dell OptiPlex GX620 User Manual
Page 163
7.
Pull up on the drive release latch and slide the floppy drive towards the back of the computer. Then lift up to remove the drive from the computer.
Installing a Floppy Drive
1.
.
2.
Align the screws on the drive with the bracket rails in the computer, and gently position the drive until it clicks into place.
3.
Insert the floppy-drive cable into the cable release tab on the floppy drive and press down on the tab until it clicks to lock it in place.
4.
Insert the floppy-drive cable into the cable release tab on the system board and press down on the tab until it clicks to lock it in place.
1 cable release tab
2 data-cable edge connector
NOTE:
In the event the replacement or new floppy drive does not have the shoulder screws, use the screws located within the drive-panel insert.
1 drive
2 screws (3)
3 bracket rails (3)