NISSAN 2008 Nissan Altima User Manual

Page 93

Advertising
background image

● Malfunction Indicator Light blinking — An

engine misfire has been detected which may

damage the emission control system. To re-

duce or avoid emission control system dam-

age:

– do not drive at speeds above 45 MPH

(72 km/h).

– avoid hard acceleration or deceleration.
– avoid steep uphill grades.
– if possible, reduce the amount of cargo

being hauled or towed.

The Malfunction Indicator Light may stop blinking

and come on steady. Have the vehicle inspected

by a NISSAN dealer. You do not need to have

your vehicle towed to the dealer.

CAUTION

Continued vehicle operation without hav-

ing the emission control system checked

and repaired as necessary could lead to

poor driveability, reduced fuel economy,

and possible damage to the emission con-

trol system.

Security indicator light

This light blinks when the ignition switch is in the

OFF, LOCK or ACC position.

The blinking security indicator light indicates that

the security systems equipped on the vehicle are

operational.
For additional information, see “Security sys-

tems” later in this section.

Slip indicator light (if so

equipped)

This indicator light will blink when the traction

control system is limiting wheel spin. Slippery

road conditions may exist if the slip indicator

blinks on. If this happens, adjust your driving

accordingly.
The slip indicator light also comes on when you

push the push-button ignition switch to the ON

position. The light will turn off after about 2 sec-

onds if the system is operational. If the light does

not come on or does not go off, have the Traction

Control System checked by a NISSAN dealer.

Traction Control System off

indicator light (if so equipped)

This indicator light comes on when the traction

control off switch is pushed to OFF. This indi-

cates the Traction Control System is not operat-

ing.
Push the traction control off switch again or re-

start the engine and the system will operate nor-

mally. See “Traction Control System (TCS)” in the

“Starting and driving” section of this manual.
The traction control light also comes on when you

push the push-button ignition switch to the ON

position. The light will turn off after about 2 sec-

onds if the Traction Control System (TCS) is

operational. If the light stays on or comes on

along with the SLIP indicator light while you are

driving, have the Traction Control System

checked by a NISSAN dealer.
While the Traction Control System is operating,

you might feel slight vibration or hear the system

working when starting the vehicle or accelerat-

ing, but this is normal.

Turn signal/hazard indicator

lights

The appropriate light flashes when the turn signal

switch is activated.
Both lights flash when the hazard switch is turned

on.

Vehicle Dynamic Control off

indicator light (if so equipped)

This indicator light comes on when the Vehicle

Dynamic Control off switch is pushed to OFF.

This indicates the Vehicle Dynamic Control is not

operating.

Instruments and controls

2-15

REVIEW COPY—

2008 Altima (alt)

Owners Manual—USA_English (nna)
02/13/08—debbie

Advertising